사용자 설명서 PHILIPS HP6301

[. . . ] For safety reasons, periodically check the cord for damage and replace it if necessary. 1 Description 1 2 2a 3 4 5 Foil protection cap Shaver foil InterFace trimmer Cutter block Release button Pop-out long hair trimmer 6 Switch 7 3775 model: Dual function light: charging (green) / low charge (red) HP6301 model: Charging light (green) 8 Shaver socket 2 Charging the shaver · When charging for the first time: Connect the shaver to the mains and charge it for at least 4 hours (switch position «off»). Then shave without the cord until the batteries are fully discharged. Then recharge to full capacity again (subsequent charges will take about 1 hour). [. . . ] Then recharge to full capacity again (subsequent charges will take about 1 hour). The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity. 3775 model: The red low-charge light glows when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 1 to 2 shaves. A full charge will give up to 30 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles. 4. 2 Replacing the shaving parts · To maintain 100% shaving performance, replace your foil and cutter block every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. 3000) · Press the release buttons, take off the shaver foil. Replace the new shaver foil in the right direction until it locks in place. · To remove the cutter block, lift it off (g). · To replace the cutter block, snap onto the holding studs. 4. 3 Preserving the rechargeable batteries · In order to optimise the capacity and life of the batteries, the shaver should be fully discharged through regular use every 6 months approximately. This reconditions the rechargeable batteries. · Do not expose the shaver to temperatures of more than 50 °C for long periods of time. 5 Environmental notice This product contains rechargeable batteries. [. . . ] · To replace the cutter block, snap onto the holding studs. 4. 3 Preserving the rechargeable batteries · In order to optimise the capacity and life of the batteries, the shaver should be fully discharged through regular use every 6 months approximately. This reconditions the rechargeable batteries. · Do not expose the shaver to temperatures of more than 50 °C for long periods of time. 5 Environmental notice This product contains rechargeable batteries. [. . . ]