사용자 설명서 PHILIPS HD6180

[. . . ] Essence Fryer HD6180 2 3 4 ENGLISH 6 16 24 32 HD6180 6 ENGLISH Important Read these instructions for use carefully before using the appliance and save them for future reference. Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Only connect the appliance to an earthed wall socket. If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. [. . . ] Release the button once the required frying time has been reached. - The maximum time that can be set is 99 minutes. - A few seconds after you have set the frying time, the timer will start counting down. - While the timer is counting down, the remaining frying time blinks on the display. The last minute is displayed in seconds. If the preset time is not correct, you can erase it by pressing the timer button for 2 seconds at the moment the timer starts counting down (i. e. Keep the button pressed until '00' appears on the display. You can now set the correct frying time. When the preset time has elapsed, you will hear an audible signal. After 10 seconds the audible signal will be repeated. You can stop the audible signal by pressing the timer button. ReFresh indication For better, tastier and healthier frying results, this appliance is equipped with a ReFresh function, which advises you when to change the oil or fat. After 6 hours of frying, the ReFresh symbol will appear on the display and will start blinking, advising you to change the oil or fat (see section 'Changing the oil or fat'). 1 After having changed the oil or fat, press the ReFresh button for at least 2 seconds to reset the frying session counter (fig. The ReFresh function does not interfere with the frying process, which means that you can always continue frying without changing oil or fat. After frying 1 Lift the handle to raise the basket to its highest position, i. e. 2 Open the lid by pulling the lid release lever. The lid will open automatically (fig. 3 Carefully remove the basket from the fryer. If necessary, shake the basket over the fryer to remove excess oil or fat (fig. Put the fried food in a bowl or colander containing grease-absorbing paper, e. g. 4 Switch the fryer off by means of the on/off switch. The pilot light in the on/off switch will go out. Do not move the fryer until the oil or fat has cooled down sufficiently. 10 ENGLISH Always remove and empty the water reservoir after frying. The water reservoir and the water in it can be hot!Let the water reservoir cool down sufficiently before removing it from the fryer. 5 Empty the water reservoir in the sink (fig. The lid of the water reservoir is detachable. The reservoir and its lid can be cleaned in the dishwasher or in hot water with some washing-up liquid. If you do not use the fryer regularly, we advise you to remove the oil or liquid fat and to store it in well-closed bottles, preferably in the refrigerator or in a cool place. [. . . ] Always empty the water reservoir after you have used the fryer. If you are frying large quantities, empty the water reservoir after having fried 1. 6 kg of frozen French fries or when the maximum water level has been reached. Check whether the water reservoir has been inserted properly (you will hear a click). The water reservoir has not been inserted properly. The PreClean function cannot be activated. More than 30 seconds elapsed Switch the appliance on again by means of between the moment the the on/off switch. [. . . ]