사용자 설명서 PHILIPS FC8428

[. . . ] Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum cleaner is switched on and the hose is connected to the vacuum cleaner. When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become clogged, causing the passage of air through the dustbag to become obstructed. As a result, the dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the dustbag is not full at all. Never use the appliance without the Motor Protection Filter. This could damage the motor and shorten the life of the appliance. Only use Philips s-bag` double-layer paper dustbags or the reusable dustbag provided. [. . . ] Preparing for use Hose 1 To connect the hose, push it into the appliance and turn it clockwise (fig. To disconnect the hose, turn it anticlockwise and pull it out of the appliance. 2 Connect the tubes to each other and to the handgrip by inserting the narrow section into the wider section while turning it a little. The tube with the clip is the lower tube (fig. You can connect the accessories in the same way. Disconnect the accessories and tubes by pulling them and turning them a little. Telescopic tube (specific types only) 1 Adjust the tube to the length you find most comfortable during vacuum cleaning (fig. Combi nozzle The combi nozzle can be used on either carpets (with the brush strips folded in) or hard floors (with the brush strips folded out): 1 Push the rocker switch on top of the combi nozzle with your foot to make the brush strips for cleaning hard floors come out of the nozzle housing (fig. 2 Push the rocker switch on the other side to make the brush strips disappear into the housing (fig. Accessory clip The accessory clip can simply be snapped onto the tube. The crevice tool and the small nozzle (specific types only) can be snapped onto the clip (fig. 2 Shake out the contents into a dustbin. 8 ENGLISH 3 Close the dustbag by sliding the clip back onto the bottom edge of the dustbag. Philips reusable dustbags are available under type number FC8026. Replacing filters Always unplug the appliance before replacing the filters. Motor Protection Filter Replace the Motor Protection Filter once a year. 2 Insert a new filter into the holder with the white side pointing upwards (fig. AFS Micro Filter Replace the AFS Micro Filter every 6 months. 1 Open the grille (1) at the back of the appliance and take it out (2) (fig. 2 Remove the old filter and place the sides and the bottom edge of the new filter properly behind the 3 ridges of the holder on the inside of the grille (fig. 3 Put the grille back into the vacuum cleaner by first hooking the bottom edge of the grille into the appliance (1) and then pushing the grille towards the appliance until it snaps home (2) (fig. Two AFS Micro Filters and one Motor Protection Filter are available under type number FC8032. [. . . ] Two AFS Micro Filters and one Motor Protection Filter are available under type number FC8032. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www. philips. com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Troubleshooting 1 Insufficient suction power Check if the dustbag needs to be replaced. [. . . ]