사용자 설명서 JAMO A 30 CEN

[. . . ] Sun® Sun Microsystems® Sun Microsystems, Incorporated . SPARC® SPARC International, Incorporated . SPARCstationTM SPARC International, Incorporated Sun Microsystems, Incorporated . UNIX® X/Open Company Limited . [. . . ] For more details, refer to the infoSMART Knowledge Base at www. xerox. com/officeprinting/infoSMART, Document # 33225. Parallel Connection The printer's parallel connection uses a parallel cable to connect your computer's parallel port to the printer's parallel port. Install the printer driver from your printer's software CD-ROM. Select the appropriate LPT parallel port. Ethernet Connection (recommended) Network Use an Ethernet connection with two twisted-pair (Category 5/RJ-45) cables and an Ethernet hub. Connect the computer to the hub with one cable and connect the printer to the hub with the second cable. Use any port on the hub except the uplink port. TCP/IP and EtherTalk are the most common protocols used with Ethernet cables. To print using TCP/IP, each computer and the printer requires a unique IP address. See Setting IP Addresses. Standalone Use Use a crossover cable to connect the printer directly to the computer via the Ethernet port. Setting an IP address If your computer is on a large network, contact your network administrator for the appropriate TCP/IP addresses and additional configurations. If you are creating your own small Local Area Network, or connecting the printer directly to your computer over Ethernet, use this basic procedure. The printer and computer(s) should have unique IP addresses. It is important that the addresses are similar, but not the same. On the General tab, select the TCP/IP protocol for your network card. On the General tab, select Use the following IP address. Enter an IP address and Subnet Mask, and then click OK. (If you use the IP address in the above example, set a Subnet Mask of 255. 255. 255. 0). Click OK and restart Windows, if prompted. From the start menu, right-click Network Neighborhood and select Properties. On the Protocols tab, select TCP/IP Protocol and click Properties. On the IP Address tab, select Specify an IP Address. Enter an IP Address and Subnet Mask in the field and click OK. (If you use the IP address noted above, set a Subnet Mask to 255. 255. 255. 0. ) 4. Page 2 of 3 Installing the Printer Driver To download the latest printer drivers, access the Xerox web site at: www. xerox. com/officeprinting/support. Windows 95/98/Me, Windows 2000/XP, and Windows NT 4. x Install the printer driver from your printer's software CD-ROM. [. . . ] · Always use at least two people to lift the printer. · Always turn off the printer using the power switch. · Failure to repackage the printer properly for shipment can result in damage to the printer not covered by the printer's warranty. · Damage to the printer caused by improper moving is not covered by the printer's warranty. Moving the printer within the office The printer can be safely moved from one location within an office to another as long as it travels in an upright position, gently over smooth surfaces. [. . . ]