사용자 설명서 PHILIPS FC-9210

[. . . ] Do not point the hose, the tube or any other accessory at the eyes or ears nor put it in your mouth when it is connected to the vacuum cleaner and the vacuum cleaner is switched on. Caution - Do not suck up large objects, as this may cause the air passage in the tube or hose to become obstructed. - When you use the vacuum cleaner to vacuum ashes, fine sand, lime, cement dust and similar substances, the pores of the filter cylinder become clogged. If you notice a strong decrease in suction power, clean the filter cylinder. - Sucking up large objects may cause the air passage in the tube or hose to become obstructed. [. . . ] 6 Put the filter cylinder case back into the dust bucket and put the bucket back into the appliance. 7 Close the cover firmly (`click'). Always put the filter cylinder case back into the bucket, otherwise the appliance cannot be switched on. Cleaning and maintenance of filters Always unplug the appliance before you clean or replace the filters. The filter cylinder and the filter cylinder case are not dishwasher-proof. Filter cylinder Clean the filter cylinder every 2 months. 1 switch off the appliance and remove the hose. 2 Press the release button on top of the dust bucket handle to unlock the cover (1). swing open the cover (2). 3 lift the dust bucket out of the appliance. 14 EnGlIsh 4 lift the filter cylinder case out of the bucket. 5 Turn the handle on top of the filter cylinder case anticlockwise (1) and lift the filter cylinder out of the case (2). 6 Clean the filter cylinder and the case with the brush supplied. Brush from the top of the filter downwards along the ribs of the filter. Other brushes may damage the filter cylinder. 7 if there is dirt on the inside of the case, empty the case over a dustbin. 8 if you wish, you can clean the filter cylinder case with cold tap water and some washing-up liquid. 9 if you want to wash the filter cylinder, wash it thoroughly with only water. Do not use any soap, washing-up liquid or other detergent to clean the filter. let the filter cylinder dry completely before you reinsert it into the case. 10 Put the filter cylinder back into the case and turn the handle clockwise until the filter cylinder locks into position. Make sure the filter cylinder is securely fixed in the case. 11 Put the case with the filter cylinder back into the dust bucket. Motor protection filter Clean the permanent motor protection filter every time you clean the filter cylinder case. 1 Take the motor protection filter out of the appliance. Clean the filter by tapping the dust out of it over a dustbin. [. . . ] 2 2. 24 - : . - :. 1 . 1 . 2 (1). (2). 26 3 . 4 . . 2 (1). (2). 3 . 27 4 . 5 (1)(2). 6 . 2 . 28 , HEPA 12 HEPA 13 , HEPA 12 HEPA 13 . [. . . ]